Selec PID CONTROLLERS PID 500 (48x48),Full Featured PID Controller

Selec make PID CONTROLLERS PID 500 (48x48),Full Featured PID Controller







Selec Make PID Controllers - PID500 (48x48) | Full Featured PID Controller

 

FEATURES

 

 

Ø   Auto tune PID
Input : J, K, T, R, S, C, E, B, N, L, U, W,B, Platinel II
           RTD (2 wire / 3 wire): PT100, Linear mV: -5 to 56mV, Current: 0 / 4 to 20 mA, Voltage: 0 to 10V DC

Ø   Max 3 output

Ø   Output 2 programmable as Heat / Cool / Alarm

Ø   Output 3 programmable as an alarm

Ø   Selectable lower display option

Ø   Selectable temperature unit - °C / °F

Ø   Auto / Manual mode

Ø   4 Zone PID

Ø   Heat-Cool PID algorithm

Ø   Ramp-Soak

Ø   Soft Start (set point ramping for process startup)

Ø   85 to 270V AC/DC supply voltage(24V AC/DC optional)

 

 

OPTIONAL

Ø   18V DC output to drive SSR

Ø   Linear DC outputs (0 to 10 V, 0 to 20mA, 4 to 20 mA)

Ø   Heater Current Monitor and Heater Break Alarm

Ø   Remote set point input (4 to 20 mA / 0 to 10V)

Ø   Motorized input (with position feedback)

Ø   RS485 communication

Ø   Retransmission output

 


We are specialized in building PLC Control Panels and we deal with SELEC Products - PLCs, Digital Electrical Panel Meters,PID Temperature Controllers,Timers,Counters,Process Indicators,Protection Relays. We will Assist you in Programming, Installation and Commissioning of PLC’s , SCADA, Touch Screen HMI’s etc., We are also Deal with SMPS,Relay Board ,Proximity Sensors, Photoelectric Sensor, Push Button, Indicator Lights, Encoders ,Pressure Sensors, Thermocouple Sensor(NABL Calibration), RTD Sensor, Contactors, MCB's, MCCB's, Wires

 

For a Free Quote and for datasheets mail us at sales@selectautomation.net

 

Visit us at www.selectautomation.net


Selec make PID CONTROLLERS PID 500 (48x48),Full Featured PID Controller(www.selectautomation.net)

 


pid,temperature,controller,dual,display,full,featured,ecnomical,pid,controllers,selec,make,pid,500

1 comments:

Trideep said...

I am using PID controller for temperature control. If the temperature is less than the set value the relay should switch on. But the exactly opposite thing is happening ie it is working for cooling operation. How can I make it work for heating application???

Post a Comment